Infinite Glass - Twisty Blunt - 5.5"

A blunt is a cigar that has been hollowed out and filled with CBD, Delta 8, or cannabis flower.

One key difference is that a blunt contains nicotine and a joint does not.

Step 1: Grind

Take a small amount of cannabis flower and break it up with your hands or a grinder.

Step 2: Pack

Pack the cannabis into the bowl of the pipe. The key is to not overpack the bowl. Packing the cannabis too tightly will restrict airflow, making it harder to smoke.

Step 3: Cover the Carb

Hold the pipe in the palm of your hand and place your finger or thumb over the carb, which depending on the type of pipe you're using, will either be on the side of the end of your pipe. If you're using a one-hitter, there's no carb to cover.

Step 4: Light It

Spark your lighter close to the surface of the bowl and inhale, keeping your finger on the carb. This will draw the flame to the bowl, ignite the flower, and create the smoke to inhale through the stem.

Step 5: Inhale

Once your flower starts to combust and cherry (the hot red part), lift the flame away from the bowl. You can keep the cherry burning by covering and uncovering the carb using a tapping motion while you inhale.

Step 6: Exhale and Repeat

Exhale and repeat until you've smoked all the cannabis in the bowl.

Check out our blog on how to clean your pipes here.

You can use any type of dried flower you want! CBD or THC. 

​

New to smoking? Read our blog: How to Pack and Smoke a Bowl

Also be sure to check out: All About Weed Measurements

Step 1: Gather Your Bong Cleaner and Start Prep

First and foremost, you’ll need to make sure you have what you need for a thorough cleaning. We recommend using 91-99% isopropyl alcohol for the best results. You’ll also want to grab a plastic bag, your bong, and a pair of gloves, if you’d like. 

Step 2: Do a Water Rinse

Start out by doing a simple rinse of your bong with some warm water. Add some to the inside of your bong and give it a few gentle shakes to distribute the water around. 

Empty the water out before you move on, then set your bong inside of the plastic bag you grabbed earlier.

Step 3: Add Some Salt and Alcohol

Place your bagged bong in the sink, then pour in your isopropyl alcohol to a point that’s about half of the usual amount of water you’d add in to smoke.

Next, add some coarse salt through the mouthpiece (the part you place your lips on to inhale) and into the bong. 

Step 4: Get Shakin’

Carefully shake the salt and alcohol mixture in your bong to ensure it gets into all the nooks and crannies.

Step 5: Let it Soak

After you’ve done some shaking, allow your bong to sit and soak for around 30 minutes or so.

Step 6: Empty, Rinse, and Repeat

Step 7: Dispose of Your Bong Bag

​

Read full blog here.